First, you need to remove all the old turf. If you have an area larger than a few square metres, it’s worth hiring a turf cutter. It will make the job much quicker and easier and it helps take the hassle out of achieving a level surface.

To enhance its good looks for years to come, Namgrass should have a neat, durable edge around it. When choosing which material to use (timber, metal, concrete or brick) remember Namgrass is available in pile heights from 16mm to 38mm deep, so you should lay the height of your edge accordingly. Next, have a nice cup of tea.

Once the edge is in place, the entire area needs to be covered with a layer of Type1. Although the depths can vary due to condition and use of the area, a typical base will consist of between 50-70mm of Type1 aggregate and a 20mm top layer of compacted and levelled Grano dust also known as ‘Fine Type 1’ which has particles no bigger than 5mm. Your local builder's merchant will be able to advise and supply materials. Take along your measurements, including the depth, so they can calculate the quantity.

Next, another trip to the hire shop for a compacter which is needed to compress the material and provide a firm base. Depending on which Namgrass you choose, keep the base layer roughly 20mm below the top of your edging. Remember to form a slight camber so the base slopes towards the edges, this will help accommodate any settlement over time.

It’s a good idea to spray the area with water to keep the dust down and help the aggregate to bind. Then it’s time for another cup of tea. Finally, (phew!) cover the base layer with a weed membrane, pinning it close up to the edging.

Now for the fun part! Lay the Namgrass over the area and overlap the edges so you have enough material to trim for a close finish. Chances are, you’ll need to join two or more pieces together, roll these pieces out as well, ensuring the pile runs the same way. Namgrass is best viewed with the pile direction facing towards you however the majority of our grass can also be laid side-on. Leave the Namgrass to settle for a couple of hours. Break for lunch.

Come on, come on, back to work. Carefully cut the overlapping edges, sharp knife essential, so they fit snugly up to your edging. Whilst it’s not essential, some high use areas, such as family gardens, benefit from an even layer of kiln-dried sand infill – approx. 5 kilos/m². This provides additional stability and weight to the product, thus making for a much nicer completed project. After spreading the sand, brush up the grass to lift the pile and settle the sand in. More tea. If you are a pet owner we suggest not infilling with sand to ensure a lawn that smells fresher for longer.