Brief usage instructions

• Do not apply to natural stone. Do not apply to painted surfaces or those that have been previously treated with silicone sealants or other water repellent materials
• Always test a small inconspicuous area before use to ensure surface compatibility, performance and finish is acceptable
• EASYSeal BCS is best applied on a dry surface but can be used on damp (not wet) surfaces. Do not apply if there is standing water
• Avoid applying within 24 hours of predicted rainfall
• Shake well before use
• Treat any efflorescence prior to application and allow a suitable length of time to elapse to ensure efflorescence does not reoccur
• Clean any jointing sand from the surface and the bevelled edge of interlocking blocks
• The surface must be clean and free from contamination or previously applied finishes. Remove any marks, stains or dirt from the surface because such will be permanently sealed in after application. Surfaces should be free from any mould or fungal growth, waxes or coatings
• Protect from rain between coats and for at least 24 hours after the final coat
• Allow at least 8 hours before foot traffic and 3 days for vehicular traffic
• On previously untreated surfaces EASYSeal BCS penetrates as well as giving a surface coating which will result in a changed appearance. The extent of the change depends on the porosity of the material on which it is applied - anything from an absolutely matt finish to a gentle sheen or satin look
• Keep pets away until surface is fully dry
• Do not apply when the surface temperature is below 5℃

1. Apply with a brush, roller or low pressure sprayer at a rate of 3m2 per litre for the first coat
2. Work diagonally across the joints, in straight lines and in one direction. Do not allow the material to pool
3. When working with interlocking blocks take care not to pick up any sand from the joints. Whilst not allowing the material to pool, ensure sufficient is applied to soak into the sand
4. Apply two coats. If using a brush or roller, apply the second coat by brushing/rolling at rightangles to the previous coat at a rate of 4 - 6m2 per litre. Apply the second coat between 3 and 24 hours after the first coat is touch dry