A-Joint Pro - Paving Grouting (Jointing Compound)

Quick Find Code: 050084
main product photo

A-Joint Pro - Paving Grouting (Jointing Compound)

Quick Find Code: 050084
Grouped product items
Product Name Price inc VAT Qty
Neutral - 25Kg
£90 .00  per item
inc VAT
Stone Grey - 25Kg
£90 .00  per item
inc VAT
Basalt - 25Kg
£90 .00  per item
inc VAT
delivery included

A-Joint Pro is perfect for heavier trafficked areas as it is load-bearing up to 12 tonnes. 

A-Joint is top quality and is resistant to frost, ice, salt, weeds, and abrasions. which is particularly suitable for narrow and extra-wide joints due to its self-compacting properties and high flowability. What's more, it is also very cost-effective and can permanently fix the joints between almost all natural and concrete paving types without using a lot at a time. We are a major stockist of all 3 A-Joint colours. 

Neutral is a buff sand-like colour, Stone Grey is as the name suggests a light grey, and Basalt is a dark grey almost charcoal colour suited to darker paving options. 

More Information
Quick Find Code 050084
Manufacturer A-Joint
Container Coverage 1 tub covers 15 - 20sqm on a 15.3sqm patio pack of paving slabs, please see spec for indepth measurements
Container Size 25kg
Size NA
Usage Instructions

Prepare:

The joints must be cleaned of weeds, roots and loose parts without leaving any residue and cleared to a depth of at least 25 mm (2/3 of the stone height for traffic load). The surface to be grouted must be freed from all dirt. Adjacent areas that are not to be grouted should be masked or covered. To avoid settling and loose stones, we recommend a permanently water-permeable and load-bearing substrate corresponding to the subsequent load (pay attention to the current standards and guidelines). We generally recommend the bonded construction method.

Pre-Wetting

Pre-wet the entire surface extensively. Higher soil temperatures and absorbent, open-pored stones require more intensive pre-wetting. Generally, use clean and cold water.

Mixing bucket

Open the bucket. Pour the bottle inside completely to the sand component. Fill the emptied bottle to ¼ = 0.25 litres of water and close it, shake vigorously and add to the mixture. Make sure the bottle is completely empty. Use a professional stirring or mixing device. Start the mixing process and mix thoroughly for at least 6 minutes until a creamy, flowing mass is obtained. No further addition of water is necessary.

Filling the joints:

Pour the finished mixture onto the well pre-wetted surface. Work in the jointing compound carefully and as diagonally as possible to the joints using a rubber squeegee. To make the most of the flowability, it is recommended to divide this mixture into two to three portions. Mix the remaining joint compound again briefly. Keep the surface constantly wet during this work.

Cleaning the surface:

After approx. 10-20 minutes, sweep the stone surface carefully and diagonally to the joint with a medium-coarse street broom. If white gel-like streaks form on the stone surface, the correct sweeping time has not yet been reached. Then remove the remaining mortar residues with a fine coconut broom. Material that has been swept off should no longer be used. Be aware that chamfers (bevelling of the side edges) on slabs and pavers must be exposed.

   Frequently Asked Questions and Answers


FURTHER PRODUCTS IN THIS CATEGORY